Corner tidied-up

Back

Cut and dried

A piece of exterior angle stiffens the corner. I will probably add an interior angle piece as well when I come to doing the boot.

I shall shortly be concentrating on joining the boot front (the large steel sheet going across the bus, and shown here, to the rear bearer. I would like to insert a few bolts fixing it to the bearer support shown here on the left. There are no signs of bolt-holes in it, and I do not want to weaken the structure, but I think a single bolt through each support might be appropriate.

 
 

This document maintained by JohnB@crownsys.co.uk.
Material Copyright © 2006 John Braga